As an alternative, you can unplug the negative cable from your battery for as long as five minutes or remove a fuse from your engine control unit in order to reset the throttle sensor.
How do I reset my cobalt throttle body?
For three minutes, put the engine in PARK and let it idle. RPM can be monitored using a scan tool. Desired RPM should begin decreasing as a result of the ECM’s learning of the new idle cells. For 60 seconds, turn off the engine.
How do you reset the throttle position sensor on a Chevy?
After releasing the accelerator pedal and turning on the ignition switch for two seconds, you can reset your Chevy’s throttle position sensor. After ten seconds, you should turn the ignition switch off.
How do I reset my electronic throttle position sensor?
Remove the engine control module fuse or unplug the negative cable for up to five minutes to reset your throttle position sensor.
Do you have to reset computer after replacing throttle position sensor?
If your engine light was on and you had a pending code, it will go away after you replace the throttle body. ECM (computer) hard reset would be required if the code was a permanent one.
How do I calibrate my accelerator pedal position sensor?
Assemble the accelerator pedal and calibrate it as needed:Once the ignition switch has been turned on and the accelerator pedal has been fully depressed from idling to full throttle, the ECM and accelerator pedal must be recalibrated. The procedure should be repeated three times for best results.
Does a throttle body need to be calibrated?
Using MEITE, you can calibrate the Throttle Position Sensor (TPS) once it has been installed. To begin, double-check that the throttle sensor signal input is set to “TPS Raw” in the Analog Settings and that it is properly wired.