You can easily remove the Dyson Animal brush head by following these steps:
Lift up the handle of the vacuum cleaner and detach the hose from the top of the machine and remove the screws on both sides of the grey base at the rear of the machine, using a screwdriver, and remove this cover. Then Reach inside and pull out the clear bin from behind, making sure not to pull on the wires connected to it, and disconnect both ends of this wire from their sockets and take out this clear bin from inside the machine.
Keep your vacuum cleaner on a flat surface and turn it upside down. Press down on its handle to release its suction pads, located at its base, from their slots under it, and lift up this handle carefully to detach it from its position on top of your vacuum cleaner. Then remove all hair tangled around the axle that is attached to a small wheel within your brush head and then push open this wheel’s lock latch with your fingers and rotate it counter-clockwise to detach its axle from your brush head’s main body.
How do you clean the brush head on a Dyson Mini?
Turn the end cap counterclockwise by a quarter turn using a coin. You can now get rid of it. There should be a small padlock icon and arrows to help you open the end cap. Take out the Brush bar from the Quick-release Mini motorized head and remove any hair or fibers.
How do you remove the wand from a Dyson Animal 2?
The wand release button is located on the front of the vacuum handle. To release the lock, press the large release button just above the power switch. Hold the release button while pulling up on the grip handle. Push the release button in. In time, the wand will fall out of its bracket.