Turn the CATS off and then back on by pressing the power button. During the start-up cycle, push on the unit to see if the CATS activates. If it does, press “reset” to pause the cycle, then press “reset” again to return the unit to home position.
How do you force a Litter-Robot to cycle?
Click on “Cycle” to begin. With a solid blue light, the device should cycle and return to the Home position. Press the Reset button on your cat sensor to reset it. By pressing the globe above the entrance in a forward and downward motion, you can see if CATS is working properly.
Why is my Litter-Robot not working?
Remove the globe and cover after turning the machine off. Look for a blockage in the gears or the motor. Re-assemble the unit and check the litter level. Then turn the unit on—if the problem persists, contact Customer Service at 1-877-250-7729, [email protected], or litter-robot.com/help.
Why is my Litter-Robot stuck on cycle?
Check for stuck litter, especially if you recently cleaned your unit (leftover moisture may have interacted with the litter) (leftover moisture may have interacted with the litter). Cleaning the Globe is necessary if you see or suspect that there is litter caked behind the display screen (the screen should not be bent outward to clean behind).
Why does my Litter-Robot keep going offline?
The app store calls it “Whisker.”There is a solution to this problem: Your Litter-Robot needs a hard reset. Unplug the unit and wait one minute before plugging it back in to allow it to complete a full cycle. Proceed to the next step if the app still shows offline. If it does, please check it. Restart the router.
Why does the blue light keep flashing on my Litter-Robot?
You should change your Litter-drawer Robot’s if the Litter-blue Robot’s light flashes when it’s full.
What is cat sensor fault on Litter-Robot?
Activating the cat sensor (CATS) for more than two minutes results in the blinking yellow light changing to the blinking red light. Please remove any unnecessary weight from your device and inspect it for the following issues: The litter is over the 10lb mark or the fill line.
Why is my Litter-Robot not connecting to WiFi?
For those of you who are an Android user: Smart Network Switches on Android devices prevent them from connecting with Litter-Robot WiFi. Before attempting to board, please make sure that Airplane Mode is enabled. Turn on your WiFi, then select the Litter-Robot network and enter the neverscoop password and proceed with onboarding when you arrive at step 4.
Where is the Litter-Robot full sensor?
The sensors are located to the left and right of the chute’s base, and can be seen if you look into the chute itself. With the globe removed, the base is seen from above and on each side. Putting it all together and turning it on.
Can multiple phones connect to Litter-Robot?
Every member of the family can use a different phone to control the Litter-Robot by using the same account. Bluetooth connectivity is available for use with the app.
Does Litter-Robot have an app?
The app for Android works well with the litter box odor-reduction product.